Turntable cutout over the board edge

Work in progress: This section is still a work in progress — content is being added and revised continuously.

What is checked? Whether the opening for a sunken turntable reaches past the edge of its board or cuts into another opening in the board. When a turntable with a cutout size sits directly on a board, Trackplanner draws this opening by itself, with the diameter from the manufacturer’s instructions. Every turntable whose opening does not lie fully within its board is reported, including at the seam to a neighbouring board.

Why does it matter? The opening appears in the construction plan, the 1:1 printout and the milling file. If it runs past the edge, Trackplanner draws it only up to the edge, and a neighbouring board gets no opening. If it cuts into another opening, the two become one hole when sawn, and the rim of the turntable has no board to rest on there.

How to fix it: Move the turntable onto the board until its opening lies fully on it and touches no other opening, or make the board larger. If the turntable sits on the seam between two boards, change the boards so that it lies on one of them.

Numbers & defaults: The diameter comes from the instructions, for example 208 mm for Arnold 6381 or 292 mm for Märklin 74861/74862. Contact up to 0.5 mm does not count. Turntables on risers or on a roadbed have no cutout and are not checked. The check is free and gives a hint.