Height not buildable with piers

Work in progress: This section is still a work in progress — content is being added and revised continuously.

What is checked? Whether a pier of the track system fits exactly at every joint of a raised viaduct or bridge. Under the bridge pieces of a system with its own piers (today Kato Unitrack N), Trackplanner puts the pier with the nearest height at every joint. If it is more than 0.5 mm off the height needed, you get the finding. For double-track viaducts the rule also reports every height for which the system has no double-track pier.

Why does it matter? The piers only come in fixed heights. If the deck sits higher than the pier, the viaduct hangs in the air at that point. If it sits lower, the pier pushes the track up and the joint kinks. With Kato the rail top is 19.2 mm above the pier top, so with the standard pier No.5 (50 mm) it is 69.2 mm above the ground.

How to fix it: Choose “Ramp to pier steps” on the finding or in the height profile of the strand. The ramp then climbs at the Kato grade of 10 mm per 248 mm (4 %): each joint gets the highest pier that stays within that grade since the last joint on a step. On 248 mm pieces that is 10 mm per joint. The ground joint and the joint after it get no pier, because the viaduct lies on the ground there. Then come No.0.5, No.1.5, No.2.5 and No.3.5 from set 23-016 and No.5, and the track continues level after that. On shorter pieces and curves, not every joint reaches a step. Such a joint gets no pier, the viaduct carries across it, and the check stays quiet. If you want a different height, set it by hand so that a pier matches it. The ramp only needs the incline piers No.1 to No.4 from 23-015 on shorter pieces and curves. For double-track Kato viaducts there is only No.5 (23-019), so they belong at a pier height of 50 mm.

Numbers & defaults: tolerance 0.5 mm. Kato: pier top to rail top 19.2 mm (10 mm deck to the underside of the track, plus 9.2 mm of track). No pier stands at the joint to the track on the ground. Ramp: at most 10 mm per 248 mm (4.03 %).